Taking on water adventures as an angler can be a thrilling hobby, but one of the more stressful sides of boating involves launching the boat. The chore can be easier with helpers around, but if you’re alone, getting the boat on or off your trailer can seem like a tiring and impossible task.
Fortunately, there are plenty of ways to beat the learning curve and get a better feel for loading your watercraft with greater ease. The steps below should help you prepare and head out onto the sea without a hitch:
Step #1: Create a Checklist and Check It Twice!
When launching alone, the key to a smooth and successful water “landing” is to prepare everything in advance. Ensure that you have all the necessary equipment on board, from the boat gear, safety equipment, flares, gas, and other essentials.
Additionally, it’s good to check on the boat plug and the boat motor to check whether both are in good working order. Before you launch the boat onto the ramp, it’s also important to do the following preparations:
Look for an appropriate staging away from the ramp before your pre-launch preparation;
Position the antenna to an upright position;
Be sure the battery switches are on;
Check if the drain plug is installed;
You can then load all your safety equipment and other gear for your trip. Don’t forget to secure your boat fenders! Additionally, you also need to remove tie-downs and safety straps while the winch strap is loose as a proper angler etiquette.
Step #2: Approach the Boat Ramp
With your boat attached to the back of your truck, you can stage your launch once the boat is at the water’s edge. Park your car and then tie a dock line from the bow of your boat to your vehicle. Be sure to rope is at an appropriate length since it will be the primary key that helps you maneuver the boat when it reaches the water.
Step #3: Launch the Boat
With the rope securely attached to the bow cleat and your tow vehicle, you can now safely unhook the winch cable. Get inside your vehicle and slowly back your boat into the water until it starts to float.
Once it does, press on the brakes to encourage the boat to break free, and then set the parking brake so you can disconnect the dock line, which you can still use to move the boat to other access points or onto a dock cleat.
The Bottom Line: An Angler’s Guide on How to Easily and Safely Load Your Boat
Launching a boat successfully is a trial and error process, but the simple steps above should cover the basics. However, it’s important to accept help whenever possible, or at least invest in a boat loading support system that can take the hassle out of launching your boat.
Where Can You Find an Easy Boat Loading Support System in Indiana?
Whether you’re an aspiring angler or a watercraft veteran, it’s important to polish your skills and work with the right equipment to ensure you can safely load or unload your boat. Fortunately, we can make watercraft loading easier for you with our float system for boats, so check us out today and explore our extensive selection today!